Albert Caster Wheels Manual

How to put caster wheels on the legs of the Albert Stand:

Albert Lockable Caster Wheels – Mounting guide

In the package:
- 4 caster wheels with mounting screw and nuts
- 8,5 mm drill-bit
- Tool to hold the nuts when mounting

 Please follow the steps below

 - Take of the plastic cover on the end of each stand leg

 - Drill holes for the caster screw (if the hole not there from before). Use the
    attached tool with the small hole mark to find the center for drilling the hole.
     (Make sure to center the hole so the nut tool match)

 - Put the nut in the tool and enter the caster screw

 - Use a (13 mm) and tighten the nut when holding the tool on the inside of the
    metal-leg bar

 - Put back the plastic cover (upside down as the previous position)